Chapter 6: Creating and Editing Sounds
Page 104
Fine Adjustment of the End Point of a Zone
Select the End: field in the ZONE mode and press OPEN WINDOW to open the Zone end fine
window.
........................
......................................................................................................
........................................................................................................
............................
CLOSE PLAY XZOOM+ZOOM-
Zone end fineZone end fine
END: 55182
Lngth= 47326
PLAY X:ALLPLAY X:ALL
•
End:
Set the end point. Change the value with the DATA wheel. You can enter large numbers by
entering a number with the numeric pad and then pressing ENTER.
You can also enter numbers with thw CURSOR LEFT/RIGHT keys while holding the SHIFT
key.
Note: If you adjust the end point, the start point of the next zone will also change.
•
Lngth=
The length of the zone (from the start point to the end point) is displayed. You cannot
change the value of this field.
You can enlarge or reduce the sample wave display by pressing ZOOM+ [F3] or ZOOM- [F2].
Press ZOOM- [F2] to display the entire wave and set a rough start point then press ZOOM+ [F3]
several times to make fine adjustments.
When PLAY X [F6] is pressed, you can play back the currently selected sound at full velocity
according to the settings in the PLAY X: field. For details refer to the “TRIM Mode”.
EDIT Mode
This allows you to edit the sample selected in the TRIM, LOOP or ZONE window.
From the TRIM, LOOP or ZONE screens, you can carry out various editing features by pressing
EDIT [F5].
By turning the data wheel when the cursor is in the Edit: field, the following edit modes can be
selected.
◆ DISCARD
This discards the unused sounds before the start and after the end of the selected range.
Press DO IT [F5] to execute.
........................
......................................................................................................
........................................................................................................
............................
CANCEL DO IT
Section
Edit
Edit:DISCARD
DO IT will discard.DO IT will discard.
To Next Page
Loading...
Need help?
General
