Page 55
Chapter 3: Recording Sequences
Editing the Velocity
This adjusts the velocity of the data that is recorded on the selected track when the sequence is
played.
.......................................................
..................................................................................................
Sq:01-(Sequence01)
TrMUTE SOLO Tr +
Now:001.01.00
STEP EDIT Tr -
™:120.0(MAS) Timing:1/16 Tsig: 4/ 4Tsig: 4/ 4
Count:OFF Loop: ONLoop: ON Bars: 2Bars: 2
Tr:01-Track-01 ON:YES Pgm:OFF
S:MIDI :10A-Device10 S:MIDI :10A-Device10 Velo%:100
Select the Velo%: field with the CURSOR keys and set the incremental or decremental ratio of
the velocity with the DATA wheel.
CAUTION: This setting will not directly edit the recorded data. The velocity will increase or
decrease according to the ratio set here only during playback. Also, data with a
maximum velocity (127) will not be affected by values set over 100%.
To edit the velocity of prerecorded data, use the Edit Velocity window.
To display the Edit Velocity window, select the Velo%: field and press OPEN WINDOW.
........................
......................................................................................................
........................................................................................................
............................
CLOSE DO IT
Edit VelocityEdit Velocity
Edit type:Edit type:ADD VALUEADD VALUE Value: 1Value: 1
Time:001.01.00-001.01.00
Notes: 0 (C. )-127(G.8)Notes: 0 (C. )-127(G.8)
....................................................................................
To directly change the velocity of recorded data, set the following fields and press DO IT[F5].
•
Edit type:
Select the method of changing the velocity.
ADD VALUE Adds the set Value: to the current velocity.
SUB VALUE Subtracts the set Value: from the current velocity.
MULT VAL% Increases or decreases the set Value: ratio (percentage) against the
current velocity.
SET TO VAL Sets all of the velocity values uniformly to the set Value:.
•
Value:
Sets the value of the edit method selected in Edit type:.
•
Time:
Specifies the data range to be edited when the velocity of the recorded data is edited. Any
data not specified within this range will not be edited.
• Notes:
Specifies the note range to be edited on the MIDI track when the velocity of recorded data
is edited. Any note not specified within this range will not be edited. On the Drum track,
notes can be entered by pressing the drum pads.
To Next Page
Loading...
Need help?
General
