Chapter 5: Song Mode
Page 86
Moving to a Specific Point in the Song
Select the Now: field with the CURSOR keys and set the point in the song that you want to go to
with the CURSOR keys and DATA wheel.
.......................................................
.....................................................................
................
................
................
INSERTCONVRT DELETE
TEMPO:MAS
™:120.0
LOOP:OFF
Step Sequence Reps
1 01-Sequence01 1
2 01-Sequence01 1
Song:01-Song01 Now:001.01.00
You can set the Now: field to display either bar/beat/clock or hours/minutes/seconds.
While still on the Now: field, press OPEN WINDOW.
........................
......................................................................................................
.........................................................................................................
............................
CLOSE
Time DisplayTime Display
Display style:BAR,BEAT,CLOCK
Start time:00h00m00s00f00
Frame rate:25
•
Display style:
Select either BAR,BEAT,CLOCK or HOUR,MINUTE,SEC.
•
Start time:
Select HOUR,MINUTE,SEC in Display style: to start the time display on the
main screen from the time set in this field. This is also the start time when synchronizing to
MTC or SMPTE time code.
•
Frame rate:
This sets the frame rate of the time code used when synchronizing to MTC or SMPTE time
code. Synchronization is described in the “MIDI/SYNC Mode” section.
To Next Page
Loading...
Need help?
General
