Akai MPC 2000XL User Manual

Page 56
Chapter 3: Recording Sequences
Setting the Program Change Transfer
You can send program changes on each track in addition to sending program change events
within a track when a sequence is selected.
.......................................................
..................................................................................................
Sq:01-(Sequence01)
TrMUTE SOLO Tr +
Now:001.01.00
STEP EDIT Tr -
™:120.0(MAS) Timing:1/16 Tsig: 4/ 4Tsig: 4/ 4
Count:OFF Loop: ONLoop: ON Bars: 2Bars: 2
Tr:01-Track-01 ON:YES Pgm:OFF
S:MIDI :10A-Device10 S:MIDI :10A-Device10 Velo%:100
Select the Pgm: field with the CURSOR key and set the program number you want to set with the
data wheel. The program change will not be sent if set to OFF.
To display the following window, select the Pgm: field and press OPEN WINDOW.
........................
......................................................................................................
........................................................................................................
............................
CLOSE
Program changeProgram change
Transmit program changesTransmit program changes
in this track:in this track:YES
Set the field to enable (YES) or disable (NO) the transfer of program change recorded on the
selected track. When this is set OFF, the program change will not be sent even if there is a
program change on the track.
Locating with the DATA Wheel
You can locate a point in the sequence with the DATA wheel.
.......................................................
..................................................................................................
Sq:01-(Sequence01)
TrMUTE SOLO Tr +
STEP EDIT Tr -
™:120.0(MAS) Timing:1/16 Tsig: 4/ 4Tsig: 4/ 4
Count:OFF Loop: ONLoop: ON Bars: 2Bars: 2
Tr:01-Track-01 ON:YES Pgm:OFF
S:MIDI :10A-Device10 S:MIDI :10A-Device10 Velo%:100
Now:001.01.00
To locate, select the Now: field with the CURSOR keys and increase or decrease the number
with the DATA wheel.
Units Used to Locate a Point
You can select bar/beat/clock or hours/minutes/seconds to be displayed in the Now: field.
Select the Now: field and press OPEN WINDOW.
........................
......................................................................................................
........................................................................................................
............................
CLOSE
Time DisplayTime Display
Display style:BAR,BEAT,CLOCK
 start time:00h00m00s00f00
 Frame rate:25

Akai MPC 2000XL Specifications

General

Brand	Akai
Model	MPC 2000XL
Category	Recording Equipment
Language	English