Chapter 13: Appendix
Page 196
Function **** Transmitted Recognized Remarks
Basic Default 1 - 16 1 - 16
Channel Changed 1 - 16 1 - 16
Default 3 1
Mode Messages X X
Altered X X
Note 0 - 127 0 - 127
Number True Voice 0 - 127 0 - 127
Velocity Note ON O O
Note OFF O O
After Key’s O O
Touch Ch’s O O
Pitch Bender O O
Control 0 O O See note below
Change 127
Prog O O
Change True# 0 - 127 0 - 127
System Exclusive O O ID: 45h Sequence recording only
System : Song Position O O
: Song Select X X
Common : Tune X X
System : Clock O O
Real Time : Commands O O
Aux : Local ON/OFF X X
Messages : All Notes Off O X
: Active Sense X X
: Reset X X
Note : If the Convert Sustain Pedal To Duration field (accessed from the Main Screen: select the Track Type field and
press OPEN WINDOW) is set to ON, then incoming controller 64 messages (sustain pedal) will not be recorded
into sequences. Instead, any notes that are currently pressed when a Sustain On message is received are inter-
nally held on, even after they are released, until a Sustain Off message is received. The result is that the individual
durations of notes are lengthened. This is explained further in the “Receiving MIDI Data" section earlier in the
manual.
Mode 1 : OMNI ON, POLY Mode 2 : OMNI ON, MONO O : YES
Mode 3 : OMNI OFF, POLY Mode 4 : OMNI OFF, MONO X : NO
Model: MPC2000XL (sequencer section) Version: 1.0
Date: May, 1999
MIDI Implementation Chart
~
To Next Page
Loading...
Need help?
General
