Chapter 6: Creating and Editing Sounds
Page 100
Fine Adjustment of the End Point
Select the End: field and press OPEN WINDOW to open the End fine window.
........................
......................................................................................................
........................................................................................................
............................
CLOSE PLAY XZOOM+ZOOM-
End fineEnd fine
End: 440988
Lngth= 433129
Smpl Lngth:VARISmpl Lngth:VARI
PLAY X:ALLPLAY X:ALL
•
End:
Set the end point. Change the value with the DATA wheel or enter a number with the
numeric pad and press ENTER.
•
Lngth=
The length of the sample (from the start point to the end point) is displayed. You cannot
change the value of this field.
•
Smpl lngth:
This sets a fixed point of either the end point or the length of the sample.
VARI When the end point is changed, the start point remains fixed and the length
of the sample changes.
FIX When the end point is changed, the length of the sample remains fixed and
the start point moves.
You can enlarge or reduce the sample wave display by pressing ZOOM+ [F3] or ZOOM-[F2].
Press ZOOM- [F2] to display the entire wave and set a rough end point then press ZOOM+ [F3]
several times to make fine adjustments.
When PLAY X [F6] is pressed, you can play back the currently selected sound at full velocity
according to the settings in the PLAY X: field. For details refer to the “TRIM Mode” section.
To Next Page
Loading...
Need help?
General
