Chapter 4: Editing Sequences
Page 72
Copying by Bar
You can group the data on all of the tracks in a sequence and copy them by bar measures.
Press EDIT [F2] in the Main Screen to display the event copy screen and press BARS [F2].
DO ITBARS
To Sq:80
After bar: 0After bar: 0
Copies: 1Copies: 1
TrMOVE
EVENTS USER
....................................................... ...............................................
COPY
From Sq: From Sq: 80
First bar: 1First bar: 1
Last bar: 1Last bar: 1
Set the range of bars to be copied in the left window and set the destination you want them copied
to in the right window.
All of the tracks in the sequence will be copied and inserted at the point set in the right window.
◆ Left window
•
Sq:
This selects the sequence that you want to copy. Only the sequence number is displayed.
•
First bar:
This specifies the first bar of the sequence to be copied.
•
Last bar:
This specifies the last bar of the sequence to be copied.
◆ Right Window
•
Sq:
This selects the sequence that the copy will be inseted into. Only the sequence number is
displayed.
•
After bar:
The copy is pasted after the bar set here. The original data will not be overwritten, the new
data will push back the initial data.
•
Copies:
This specifies the number of times that the copy is inserted into the sequence.
CAUTION: When you copy by bar, the data among corresponding tracks will be copied.
For example, the data on track 1 will be copied to track 1 and track 2 to track
2 and so on.
To Next Page
Loading...
Need help?
General
