Page 21
Chapter 2: The Basics
•
Low range: and High range:
These two fields control the range of the slider effect. The Low range: field determines
the parameter value that will be produced when the pad is hit while the slider is at the bottom of
its travel; the High range: field determines the parameter value that will be produced
when the pad is hit while the slider is at the top of its travel. The parameter value consecutively
changes in any position within the range. The available range for this field is determined by the
parameter selected in the Parameter: field.
TUNING : -120 ~ +120
ATTACK : 0 ~ 100
DECAY : 0 ~ 100
FILTER : -50 ~ +50
Note: The attack or decay changes within the range of 0 and 5000msec.
•
Assign NY slider to ctrl change:
This field selects the MIDI Control Change Number which controls the NOTE VARIATION
slider from an external MIDI controller.
The AFTER key
Normally, the slider only affects notes which are actually played and has no effect on notes played
back from sequences. However, if the AFTER key is pressed (and the indicator lights), the slider
also effects the drum notes playing back from sequences. In this case, the function effects the
drum note of the note number (drum pad) assigned to the NOTE VARIATION slider. Also, this
NOTE VARIATION slider data can be recorded if you are in the Overdub mode.
To return to normal operation, press the AFTER key again and the light will go off.
To Next Page
Loading...
Need help?
General
