Chapter 6: Creating and Editing Sounds
Page 99
Fine Adjustment of the Start Point
Select the St: field and press OPEN WINDOW to open the Start fine window.
........................
......................................................................................................
........................................................................................................
............................
CLOSE PLAY XZOOM+ZOOM-
Start fineStart fine
Start: 7859
Lngth= 433597
Smpl Lngth:VARISmpl Lngth:VARI
PLAY X:ALLPLAY X:ALL
• Start:
Set the start point. Change the value with the DATA wheel or enter a number with the
numeric pad and press ENTER.
• Lngth=
The length of the sample (from the start point to the end point) is displayed. You cannot
change the value of this field.
• Smpl lngth:
This sets a fixed point of either the end point or the length of the sample.
VARI When the start point is changed, the end point remains fixed and the length
of the sample changes.
FIX When the start point is changed, the length of the sample remains fixed and
the end point moves.
You can enlarge or reduce the sample wave display by pressing ZOOM+ [F3] or ZOOM- [F2].
Press ZOOM- [F2] to display the entire wave and set a rough start point then press ZOOM+[F3]
several times to make fine adjustments.
When PLAY X [F6] is pressed, you can play back the currently selected sound at full velocity
according to the settings in the PLAY X: field. For details refer to “TRIM Mode” on the previous
page.
To Next Page
Loading...
Need help?
General
