Chapter 12: MIDI/SYNC Mode, OTHER Mode
Page 186
OTHER MODE
Set the tempo with the TAP TEMPO key and initialize the data. It is also possible to check the
version of the MPC2000XL operating system.
OTHERS Screen
Hold down SHIFT and press OTHER (8 on the numeric pad) to display the OTHER mode screen.
OTHERS
...............................................................................................................
Tap averaging:3
Display contrastDisplay contrast
Hold SHIFT and turn jog(anytime)Hold SHIFT and turn jog(anytime)
INIT VER.
• Tap averaging:
Hit TAP TEMPO to set the tempo. The MPC2000XL sets the tempo to the average of the
tempo tapped.
Set the number of taps used to calculate the tempo here.
When this is set to a large value, it is possible to get an accurate tempo. However, this does
not respond to rapid changes in the tempo.
When this is set to a small value, the function will be able to cope with rapid changes in the
tempo, but the inaccuracy of the displayed tempo will increase.
Hold down SHIFT and rotate the DATA wheel to set the contrast of the LCD. It is possible to
change this regardless of the displayed mode.
INIT Screen
Hold down SHIFT and press OTHER (8 on the numeric pad) to display the OTHER mode screen
and press INIT [F2] to display the INIT screen.
Initialize ALL PARAMETERSInitialize ALL PARAMETERS
Pressing DO IT will initialize!!Pressing DO IT will initialize!!
INIT VER.
DO ITOTHERS
Pressing DO IT [F6] erases the parameter data from the MPC2000XL memory and initializes
them to their default parameters.
To Next Page
Loading...
Need help?
General
