Chapter 11: Flash ROM
Page 176
Note: Do not turn the MPC2000XL off during de-fragmentation. The data in the
flash ROM will be destroyed and cannot be recovered.
........................
......................................................................................................
........................................................................................................
............................
Processing.....
F-ROM Fragmentation
.....................................................................................................
The above window appears during de-fragmentation.
Note: It will take several minutes to complete the operation.
Editing a Sound within the Flash ROM
When sound data stored in the flash ROM is loaded, only the location information of the data is
loaded to the RAM, wave pattern data is not loaded. Therefore, you can handle more data on the
RAM. However, to edit wave pattern data within the flash ROM, it is necessary to load it tempo-
rarily into the RAM.
In the same way as you would normally load sounds, load the sound from Flash ROM by holding
down SHIFT and pressing LOAD (or 3 on the numeric pad).
At this point, the wave data has not yet been transferred to the MPC2000XL's RAM .
Load the same sound again, the wave data will be transferred to the RAM.
You can perform all the normal editing operations after the wave data has been transferred to the
RAM.
When you have finished editing, save the data back to the flash ROM.
If you enter the same name as the original data, you can overwrite the original.
To Next Page
Loading...
Need help?
General
