99
MPC500 Operator's Manual rev 1.0
Loading the All File
You can load the ALL file, which has sequence and song data. When you load the ALL file, all the sequences and songs, which are
currently in the MPC500, will be replaced by the new data.
1. Select the ALL file and load it.
2. The Load ALL (SEQS&SONGS) File window will be displayed.
3. In the 'Parameter' field of the Load screen, make sure All seq&songs is selected and press the [DO IT] button.
The MPC500 will start loading the data.
Loading an Individual Sequence from the All File
You can load an individual sequence from an ALL file
1. Select the ALL file and load it.
The Load ALL (SEQS&SONGS) File window will be displayed.
2. In the 'Parameter' field of the Load screen, make sure Single seq is selected and press the [DO IT] button. The
following screen will be displayed.
3. In the 'Load file' field, select the sequence to load.
4. In the 'Ld' field, you can select a sequence inside the selected ALL file.
5. In the 'To' Field, select the destination sequence.
Select the sequence number to load the data to.
6. Press the [DO IT] button.
The MPC500 will start loading the data.
Loading a Project
When you use SAVE ENTIRE MEMORY mode to save the data, the MPC500 will load the project file that will be created. When you load
a project file, all the data currently saved in the unit will be overwritten by the data that the project file will load.
1. Select a project file and press the [DO IT] button. The CAUTION window will be displayed.
2. Press the [DO IT] button to clear all memory from the MPC500 and load the selected project file.
Loading a Folder
You can load all of the files within a folder at the same time. You can load programs, samples, and ALL file. Sequence and Project files are
not loaded.
1. Select the folder to be loaded and press the [DO IT] button. This will show the following page:
Here, you can choose whether loading the folder will clear the entire memory contents.
To Next Page
Loading...
Need help?
General
