37
MPC500 Operator's Manual rev 1.0
ADD VALUE - Add value of 'Amount' field to velocity of selected events
SUB VALUE - Subtract value of 'Amount' field from velocity of selected events
MULTI V% - Multiply value by 'Amount' field
SET TO V - Set velocity to value of 'Amount' field
'Amount' Field
This is the amount that the velocity will be changed by. You can set the Value between 0 and 127. When you select "MULTI
VAL%" in the 'Mode' field, you can set the Value between 0 and 200.
Pressing the [DO IT] button will execute the selected operation. After [DO IT] is pressed, MPC500 will go back to Main
sequence page.
Edit Duration
You can edit the duration of multiple note events at the same time.
Edit S, T Field
The edit selection consists of two fields, 'S' and 'T'. The 'S' field represents the Sequence, and the 'T' field is the track. The
default setting will be the current sequence and track. There is also a selection on the right to display whether the selected track
is a Drum or MIDI type track.
'Pads/Notes' Field
This selection will display its value as either Pad data or Note data, depending on the track type set in the Track params section.
See page 25 for more information.
In
This selects where area to be edited will begin. It shows the bar, beat and pulses from left to right. You can select each of these
fields independently with the cursor.
Out
This selects where area to be edited will end. It shows the bar, beat and pulses from left to right. You can select each of these
fields independently with the cursor.
'Mode' Field
Here, you can choose one of the following methods for editing Duration amounts.
ADD VALUE - Add value of 'Amount' field to duration of selected events
SUB VALUE - Subtract value of 'Amount' field from duration of selected events
MULTI V% - Multiply value by 'Amount' field
SET TO V - Set duration to value of 'Amount' field
'Amount' Field
You can set the Value between 0 and 9999. When you select "MULTI VAL%" in the 'Mode' field, you can set the Value
between 0 and 200.
Pressing the [DO IT] button will execute the selected operation. After [DO IT] is pressed, MPC500 will go back to Main
sequence page.
Timing Correct
You can correct the timing of recorded notes.
To Next Page
Loading...
Need help?
General
