34 Chapter 4: Editing sequences
MPC500 Operator's Manual rev 1.0
Move Events
You can move events within the selected region to another location. Unlike the copy function, this function will remove the source data
from the original location. All parameters are same as Copy event.
Example:
Here is an example of how to perform a move operation. Let's say you want to move the first bar of the first track from the first sequence
into the second sequence. Do the following:
1. Press the [MODE] button, and then [PAD 10] to select SEQ EDIT.
The screen will now show SEQ EDIT mode.
2. Using the [DATA] wheel in the 'Edit select' field, choose Move events.
3. In the 'Parameter' field, choose 'From'
.
S and T will be displayed, representing Sequence and Track.
Choose S: 1, T: A1 to select Sequence 1, track 1
Tip: Next to the track number will be a display of what kind of track it is, either a MIDI (M) track, or a Drum (D) type track.
4. In the 'Parameter' field, choose 'To'
S and T will be displayed, representing Sequence and Track.
Choose S: 2, T: A1 to select Sequence 2, track 1
5. In the 'Parameter' field, choose 'Pads'
For 'Pads', choose 'ALL'.
6. In the 'Parameter' field, choose 'In'.
For ‘In’, choose the time '001.01.00'
7. In the 'Parameter' field, choose 'Out'
For ‘Out’, choose the time '002.01.00'
8. In the 'Parameter' field, choose 'Start'
For start time, choose '001.01.00'
9. In the 'Parameter' field, choose 'Copies'
To Next Page
Loading...
Need help?
General
