33
MPC500 Operator's Manual rev 1.0
Choose S: 1, T: A1 to select Sequence 1, track 1
Tip: Next to the track number will be a display of what kind of track it is, either a MIDI (M) track, or a Drum (D) type track.
4. In the 'Parameter' field, choose 'To'
S and T will be displayed, representing Sequence and Track.
Choose S: 2, T: A1 to select Sequence 2, track 1
5. In the 'Parameter' field, choose' In'.
6. For ‘In’, choose the time 001.01.00
7. In the 'Parameter' field, choose 'Out'
For ‘Out’, choose the time 002.01.00
8. In the 'Parameter' field, choose 'Pads'.
For Pads, choose ALL.
9. In the 'Parameter' field, choose 'Start'
For start time, choose 001.01.00
10. In the 'Parameter' field, choose 'Copies'
For Copies, choose 1.
11. In the 'Parameter' field, choose 'Mode'
For mode, choose REPLACE.
12. In the 'Parameter' field, choose 'Do it'.
13. Press [DO IT] while on this screen to execute the copy function.
You will notice that most of these selections are default. As parameters are changed, they are remembered, in order to speed up copying and
pasting operations. If you want to perform the same action above a second time, you could skip most of these steps, as all the parameters
would have been remembered from before.
To Next Page
Loading...
Need help?
General
