23
MPC500 Operator's Manual rev 1.0
Changing the Sequence Name
This parameter lets you name your sequence.
1. Press the [SEQUENCE] button to make sure you are in Sequence mode.
2. Press the [PARAMS] button, and scroll with the [DATA] wheel in the top 'Parameter' field to choose Sequence name.
3. In the 'Name' field, enter a new name.
Sequence names can be up to 10 characters long and can be either alphabetical or numeric. For more information on setting the name, see
the "Setting Names" section on Page 11.
4. Press the [DO IT] button.
This will close the window and go back to the MAIN page.
Copying a Sequence
This function lets you make a copy of a sequence.
1. Press the [SEQUENCE] button to make sure you are in Sequence mode.
2. Press the [PARAMS] button, and scroll with the [DATA] wheel in the top 'Parameter' field to choose Copy sequence.
3. Select the 'To/from' field and change the value to Fr (from) using the [DATA] wheel.
4. In the 'Sequence' field, choose the sequence you wish to copy.
5. Next, select the 'To/from' field and change the value to 'To' using the [DATA] wheel.
6. In the 'Sequence' field, choose the location you wish to have the sequence copied to.
7. Press the [DO IT] button.
This will make a copy of the sequence to the newly selected location.
Deleting a Sequence
This parameter lets you delete a sequence
1. Press the [SEQUENCE] button to make sure you are in Sequence mode.
2. Press the [PARAMS] button, and scroll with the [DATA] wheel in the top 'Parameter' field to choose Delete sequence.
3. Select the 'Sequence' field. Use the [DATA] wheel to choose a sequence you would like to delete.
4. Press the [DO IT] button to delete the sequence.
Deleting All Sequences
If you would like to delete all sequences on your MPC, do the following:
1. Press the [SEQUENCE] button to make sure you are in Sequence mode.
2. Press the [PARAMS] button, and scroll with the [DATA] wheel in the top 'Parameter' field to choose 'Delete
sequence'.
To Next Page
Loading...
Need help?
General
