58 Chapter 8: Q-Link slider
MPC500 Operator's Manual rev 1.0
While Recording A Sequence
When the [AFTER] button is OFF
If you move the Q-Link slider, the new Q-Link Event will be recorded and added to the existing Q-Link Events.
When the [AFTER] button is ON
If you move the Q-Link slider, the new Q-Link event will be recorded and will erase any previous Q-Link Events.
Reset Q-Link Events
In SLIDER mode, pressing ERASE button will reset all changes by Q-Link events.
For example, when using the Q-Link, the Tune of a sample is changed – pressing ERASE button will reset the tune of the sample to the
Tune parameter set in PROGRAM mode.
To Next Page
Loading...
