Akai S3000XL User Manual

EDIT SAMPLE
S3000XL Operator’s Manual Page 153
As with TRIM, the S3000XL is very considerate and won’t let you ruin good loops and if
you move the start or end points into any loop zone (shown above the waveform) you will
receive the warnings:
or
In this case, whatever editing action you perform will be ignored.
As with Timestretch and Re-sampling, if you create a new sample from any of the above
editing procedures, the original loop points will be lost and you will need to reset them.
You may select to edit in mono or stereo accordingly. Of course, this only has relevance if
the sample is stereo in which case you may prefer to edit the left and right channels
separately.
IMPORTANT NOTE ABOUT SETTING START AND END POINTS: The start and end
points are temporary whilst in the sectional edit page They are not stored anywhere. If you
leave SECT or select another sample, these will be lost and you will have to set them
again.

Akai S3000XL Specifications

General

Type	Sampler
Polyphony	32 voices
Sampling Rate	44.1 kHz
Memory	2 MB standard, expandable to 32 MB
Filter	Digital resonant low-pass filter
MIDI	In, Out, Thru
Weight	6.5 kg
Display	Backlit LCD
Storage	Floppy disk drive, SCSI for external storage
Outputs	8 individual outputs
Inputs	Stereo input
Effects	Optional EB16 effects board
Dimensions	Standard 19" 2U rackmount