Alcatel-Lucent 7210 SAS-D User Manual

Configuration and Image Loading
Page 128 7210 SAS D, E, K OS Basic System Configuration Guide
Note 1: The BOF password can be changed from default value to any other user defined value
only at the Timos level.
Note 2: It is highly recommended that user does not rename cf1:\boot.tim and cf1:\both.tim, if the
system needs to retain them during the password recovery procedure. Additionally, it is highly
recommended that the user takes a backup of all the image files, configuration files and other data.
The following logs show the system prompts displayed on the console when user forgets the
password and chooses to reset the password to factory default setting. Also, shown are the BOF
contents after and before the reset. Note that the BOF parameters are set to default after password
reset.
TiMOS BOOT LOADER
CPLD Version: 2.1
Time from clock is FRI AUG 19 09:22:46 2011 UTC
USB: USB EHCI 1.00
scanning bus for devices...
1 USB Device(s) found
Number of blocks in device 0 is 0
Number of bytes per block in device 0 is 0
Switching serial output to sync mode... done
Looking for cf1:/bof.cfg ... OK, reading
Contents of Boot Options File on cf1:
primary-image ftp://*:*@135.250.27.40/xxx/xx/xxx/xx/xxx/both.tim
primary-config cf1:\sasm.cfg
#eth-mgmt Port Settings:
no eth-mgmt-disabled
eth-mgmt-address 10.135.20.115/24 active
eth-mgmt-route 0.0.0.0/0 next-hop 10.135.20.1
eth-mgmt-autoneg
eth-mgmt-duplex full
eth-mgmt-speed 100
#uplinkA Port Settings:
uplinkA-port 1/1/1
uplinkA-address 0
uplinkA-vlan 0
#uplinkB Port Settings:
uplinkB-port 1/1/2
uplinkB-address 0
uplinkB-vlan 0
#System Settings:
wait 3
persist off
console-speed 115200
uplink-mode network
acl-mode IPv6-None
use-expansion-card-type m4-ds1-ces
no console-disabled
Hit a key within 3 seconds to change boot parameters...
Enter password to edit the Boot Options File

Alcatel-Lucent 7210 SAS-D Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS-D
Category	Switch
Language	English