Alcatel-Lucent 7210 SAS-D - Page 245

System Management
7210 SAS D, E, K OS Basic System Configuration Guide Page 245
SNTP
SNTP is a compact, client-only version of the NTP. SNTP can only receive the time from SNTP/
NTP servers; it cannot be used to provide time services to other systems. SNTP can be configured
in either broadcast or unicast client mode.
SNTP time elements include:
• Broadcast-client on page 245
• Server-address on page 246
CLI Syntax: config>system
time
sntp
broadcast-client
server-address ip-address [version version-number]
[normal|preferred] [interval seconds]
no shutdown
Broadcast-client
The broadcast-client command enables listening at the global device level to SNTP broadcast
messages on interfaces with broadcast client enabled.
CLI Syntax: config>system>time>sntp
broadcast-client
Example
: config>system>time>sntp#
config>system>time>sntp# broadcast-client
config>system>time>sntp# no shutdown
The following example shows SNTP enabled with the broadcast-client command enabled.
A:ALA-12>config>system>time# info
----------------------------------------------
sntp
broadcast-client
no shutdown
exit
dst-zone PT
start second sunday april 02:00
end first sunday october 02:00
offset 0
exit
zone GMT
----------------------------------------------
A:ALA-12>config>system>time#