System Management
7210 SAS D, E, K OS Basic System Configuration Guide Page 303
Syntax login-control
Context config>system
Description This command enables the context to configure login control.
name
Syntax name system-name
no name
Context config>system
Description This command creates a system name string for the device.
For example, system-name parameter ALA-1 for the name command configures the device name as
ALA-1.
ABC>config>system# name "ALA-1"
ALA-1>config>system#
Only one system name can be configured. If multiple system names are configured, the last one
encountered overwrites the previous entry.
The no form of the command reverts to the default value.
Default The default system name is set to the chassis serial number which is read from the backplane
EEPROM.
Parameters system-name — Enter the system name as a character string. The string may be up to 32 characters
long. Any printable, seven-bit ASCII characters can be used within the string. If the string
contains special characters (#, $, spaces, etc.), the entire string must be enclosed within double
quotes.
oper-group
Syntax oper-group name [create]
no oper-group
Context config>system
Description Platforms Supported: 7210 SAS-D and 7210 SAS-K.
This command creates a system-wide group name which can be used to associate a number of service
objects (for example, ports). The status of the group is derived from the status of its members. The
status of the group can then be used to influence the status of non-member objects. For example,
when a group status is marked as down, the object(s) that monitor the group change their status
accordingly.
The no form of the command removes the group. All the object associations need to be removed
before the no command can be executed.
To Next Page
Loading...
