System Information Commands
Page 304 7210 SAS D, E, K OS Basic System Configuration
Guide
Default no oper-group
Parameters name — Specifies the operational group identifier up to 32 characters in length.
Values [32 chars max]
create — This keyword is required when first creating the configuration context. Once the context is
created, it is possible to navigate into the context without the create keyword.
Values Keyword
hold-time
Syntax hold-time
Context config>system>oper-group
Description Platforms Supported: 7210 SAS-D and 7210 SAS-K.
This command enables the context to configure hold time information.
group-down
Syntax [no] group-down time in seconds
Context config>system>oper-group>hold-time
Description Platforms Supported: 7210 SAS-D and 7210 SAS-K.
This command configures the number of seconds to wait before notifying clients monitoring this
group when its operational status transitions from down to up. A value of zero indicates that
transitions are reported immediately to monitoring clients.
The no form sets the values back to the defaults.
Default 0
Parameters time in seconds —
Values [0..3600]
group-up
Syntax [no] group-up time in seconds
Context config>system>oper-group>hold-time
Description Platforms Supported: 7210 SAS-D and 7210 SAS-K.
This command configures the number of seconds to wait before notifying clients monitoring this
group when its operational status transitions from up to down.
To Next Page
Loading...
