Alcatel-Lucent 7210 SAS-D

To Next Page

To Previous Page

System Management

7210 SAS D, E, K OS Basic System Configuration Guide Page 309

card-type

Syntax [no] card-type card-type

Context config>system>vwm-shelf>card

Description Platforms Supported: 7210 SAS-E.

This command provides the user a better control over the modules plugged into the 1830 CWDM

device slots. The user can pre-provision acceptable modules by configuring the card-type parameter

with the appropriate card-type vwm-acronym. The modules are identified using the acronyms listed

below.

The 7210 SAS validates the configured card-types with the card-type acronym retrieved from the

clip-on device and checks the following:

• If the configured card-type matches the card-type acronym retrieved from the clip-on device,

7210 SAS allows management of the module.

• If the configured card-type does not match the card-type acronym retrieved from the clip-on

device, 7210 SAS raises an event to alert the user of mismatch in configuration. The event results

in a major alarm with the major LED set. In such a case, the card status displays “Provisioning

Mismatch” error.

• The mismatch event/trap is cleared if the module is replaced with the one that has a correct card-

type acronym. Any pending trap/event, major alarm and major LED is cleared.

If the user has pre-provisioned the card set to administratively up and the module is missing, 7210

SAS raises an event/trap. The event results in a major alarm with the major LED set to the appropriate

color. If the user has pre-provisioned the card and administratively shut it down, 7210 SAS does not

attempt to match the module’s identifier (if the module is equipped in the slot) and clear any pending

alarms. 7210 SAS retrieves any information about the equipped module to aid the user with

provisioning.

The no form of the command removes and clears the card-type information. Until the card-type is

provisioned, the 7210 SAS software does not raise any events/traps/alarms for the card and clear all

pending events/traps/alarms/LEDs.

Default No default

Parameters card-type — Identifier used to match the configured slot module with the equipped slot module. The

Table 32 and Table 33 below provides the list of acronyms that can be used to identify the supported

modules usable with the clip-on device.

Values CWDM:

SFC1A SFC1B SFC1C SFC1D SFC1E SFC1F SFC1G SFC1H SFC2A&B

SFC2C&D SFC2E&F SFC2G&H SFC4A-D SFC4E-H SFC8

DWDM:

Alcatel-Lucent 7210 SAS-D - Page 309