System Management
7210 SAS D, E, K OS Basic System Configuration Guide Page 375
clear-alarm-msg
Syntax [no] clear-alarm-msg {alarm-msg-text}
Context config>system>alarm-contact-input alarm-contact-input-id
Description This command allows the user to configure a text message for use along with SNMP trap and Log
message that are sent when the system clears an alarm. The system generates a default message if the
message is not configured. The system does not generate a trap or log if no form of the command is
enabled.
Default None
Parameters alarm-msg-text — A printable character string, up to 160 characters in length.
Values [80 chars max]
description
Syntax description description-string
Context config>system>alarm-contact-input alarm-contact-input-id description
Description This command describes an alarm contact input pin. The description provides an indication of the
usage or attribute of the pin. It is stored in the CLI configuration file and helps the user in identifying
the purpose of the pin.
Default None
Values [80 chars max]
normal-state
Syntax normal-state [open | closed]
Context config>system>alarm-contact-input alarm-contact-input-id
Description This command configures the normal state to be associated with the alarm-contact input. When the
system detects a transition from the normal state, an alarm is generated. The alarm is cleared when the
system detects a transition is back to the normal state.
Default open
Parameters open — The normal-state is identified as ‘open’. When the system detects a transition to the ‘closed’
state, an alarm is generated. The alarm is cleared when the system detects a transition back to the
‘Open’ state.
closed-state — The normal-state is identified as ‘closed’. When the system detects a transition to the
‘open’ state, and alarm is generated. The alarm is cleared when the system detects a transition
back to the ‘closed’ state.
To Next Page
Loading...
Need help?
General
