Alcatel-Lucent 7210 SAS-D - Page 420

System Commands
Page 420 7210 SAS D, E, K OS Basic System Configuration Guide
A:7210>config>system>time>ntp#
A:7210>config>system>time>ntp# show system ntp detail all
===============================================================================
NTP Status
===============================================================================
Enabled : Yes Stratum : 3
Admin Status : up Oper Status : up
Server enabled : No Server keyId : none
System Ref Id : 192.168.15.221 Auth Check : Yes
Auth Errors : 0 Auth Errors Ignored : 0
Auth Key Id Errors : 0 Auth Key Type Errors : 0
===============================================================================
NTP Configured Broadcast/Multicast Interfaces
===============================================================================
vRouter Interface Address Type Auth Poll
-------------------------------------------------------------------------------
Base i3/1/1 Host-ones bcast yes off
management management 224.0.1.1 mcast no off
Base t2 bclnt no n/a
management management 224.0.1.1 mclnt no n/a
===============================================================================
NTP Active Associations
===============================================================================
State Remote Reference ID St Type Auth Poll R Offset
-------------------------------------------------------------------------------
reject 192.168.15.221 192.168.14.50 2 srvr none 64 y 0.901
chosen 192.168.15.221 192.168.1.160 4 mclnt none 64 y 1.101
===============================================================================
A:7210>config>system>time>ntp#
oper-group
Syntax oper-group [group-name]
oper-group group-name [detail]
oper-group group-name [monitoring]
Context show>system
Description This command displays the oper-group information, member count, monitor-client count, and status
in a single line for each of the configured oper-groups.
Output Show oper-group Output — The following table describes oper-group output fields.
Label Description
Name
Displays the name of the oper-group.
Oper Status
The operational status of the oper-group.
Creation Origin
Displays if it was created manually.
Hold Up Time
The configured HOLD UP time.