System Management
7210 SAS D, E, K OS Basic System Configuration Guide Page 421
Show Output
*A:7210SAS>show>system# oper-group
===============================================================================
System Oper Group Information
===============================================================================
Name Oper Creation Hold Hold Members Monitor
Status Origin UpTime DnTime
(secs) (secs)
-------------------------------------------------------------------------------
test up manual 4 0 1 1
-------------------------------------------------------------------------------
Entries found: 1
===============================================================================
*A:7210SAS>show>system#
*A:7210SAS>show>system# oper-group test monitoring
===============================================================================
System Oper Group Information
===============================================================================
Oper Group : test
Creation Origin : manual Oper Status : up
Hold DownTime : 0 secs Hold UpTime : 4 secs
Members : 0 Monitoring : 0
===============================================================================
*A:7210SAS>show>system#
resource-profile
Syntax resource-profile [[active|configured]]
Context show>system
Description This command displays the resource-profile protocol configuration and state.
Parameters active|configure — keyword - Displays active or configured values.
Active values are those in use by the system currently. Configured values are those that have
been changed by the user and has not taken effect. For the system resource-profile parameters
that need a reboot to take effect, the active and configured values can be different. It typically
requires a node reboot or a card reset for it to take effect.
Hold Dn Time
The configured HOLD down time.
Members
Displays the number of members of the oper-group.
Monitor
Displays the number of monitoring clients.
Label Description (Continued)