Alcatel-Lucent 7210 SAS-D - Page 450

System Commands
Page 450 7210 SAS D, E, K OS Basic System Configuration Guide
*A:SASE>show#
Output for older 7210 SAS-E devices without input-fail-detection)
*A:7210-SAS-E# show chassis power-supply
===============================================================================
Chassis Information
===============================================================================
Power Supply Information
Number of power supplies : 2
Power supply number : 1
Defaulted power supply type : none
Status : not equipped
Power supply number : 2
Configured power supply type : dc (+24V)
Status : up
===============================================================================
*A:7210-SAS-E#
*A:7210-SAS-E# show chassis power-supply
===============================================================================
Chassis Information
===============================================================================
Power Supply Information
Number of power supplies : 2
Power supply number : 1
Configured power supply type : ac single
Status : up
AC power : within range
Power supply number : 2
Configured power supply type : dc (-48V)
Status : up
===============================================================================
*A:7210-SAS-E#
*A:7210-SAS-E# show chassis power-supply
===============================================================================
Chassis Information
===============================================================================
Power Supply Information
Number of power supplies : 2
Power supply number : 1
Configured power supply type : dc (+48V)
Status : up
DC power : within range
Input power : within range
Output power : within range
Power supply number : 2
Configured power supply type : dc (+24V)
Status : failed
DC power : out of range
Input power : out of range
Output power : within range
===============================================================================
*A:7210-SAS-E#