Monitor CLI Commands
Page 78 7210 SAS D, E, K OS Basic System Configuration Guide
sap
Syntax sap sap-id [interval seconds] [repeat repeat] [absolute | rate]
Context monitor>service>id service-id
Description This command monitors statistics for a SAP associated with this service.
This command displays statistics for a specific SAP, identified by the port-id and encapsulation value,
at the configured interval until the configured count is reached.
The first screen displays the current statistics related to the SAP. The subsequent statistical informa-
tion listed for each interval is displayed as a delta to the previous display. When the keyword rate is
specified, the “rate per second” for each statistic is displayed instead of the delta.
Monitor commands are similar to show commands but only statistical information displays. Monitor
commands display the selected statistics according to the configured number of times at the interval
specified.
Parameters sap-id — Specifies the physical port identifier portion of the SAP definition.
Values sap-id: null [port-id | lag-id]
dot1q [port-id | lag-id]:* | qtag
qinq [port-id | lag-id]:qtag1.qtag2
port-id slot/mda/port
lag-id lag-id
lag keyword
id 1 — 200
qtag1 0 — 4094
qtag2 *, 0 — 4094
port-id — Specifies the physical port ID in the slot/mda/port format.
If the card in the slot has Media Dependent Adapters (MDAs) installed, the port-id must be in the
slot_number/MDA_number/port_number format. For example 1/2/3 specifies port 3 on MDA 2
in slot 1.
qtag1, qtag2 — Specifies the encapsulation value used to identify the SAP on the port or sub-port. If
this parameter is not specificially defined, the default value is 0.
Values qtag1: 0 — 4094
qtag2 : * | 0 — 4094
The values depends on the encapsulation type configured for the interface. The following table
describes the allowed values for the port and encapsulation types.
Port Type Encap-Type Allowed Values Comments
To Next Page
Loading...
Need help?
General
