Alcatel-Lucent 7210 SAS-D - Page 79

Root Commands
7210 SAS D, E, K OS Basic System Configuration Guide Page 79
interval seconds — Configures the interval for each display in seconds.
Default 11 seconds
Values 11 — 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 — 999
absolute — When the absolute keyword is specified, the absolute rate-per-second value for each
statistic is displayed.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed instead
of the delta.
Sample Output
A:7210SAS-E>monitor>service>id# sap 1/1/1:100
===============================================================================
Monitor statistics for Service 10000 SAP 1/1/1:100
===============================================================================
-------------------------------------------------------------------------------
At time t = 110 sec (Mode: Delta)
-------------------------------------------------------------------------------
-------------------------------------------------------------------------------
Ingress QoS Classifier Usage
-------------------------------------------------------------------------------
Classifiers Allocated: 16 Meters Allocated : 8
Classifiers Used : 2 Meters Used : 2
-------------------------------------------------------------------------------
Sap Statistics
-------------------------------------------------------------------------------
Packets Octets
Ingress Stats: 1013264 0
Egress Stats: 163674 0
-------------------------------------------------------------------------------
Sap STP Statistics
-------------------------------------------------------------------------------
Forward transitions : 0 Bad BPDUs rcvd : 0
Cfg BPDUs rcvd : 0 Cfg BPDUs tx : 0
TCN BPDUs rcvd : 0 TCN BPDUs tx : 0
RST BPDUs rcvd : 0 RST BPDUs tx : 0
MST BPDUs rcvd : 0 MST BPDUs tx : 0
-------------------------------------------------------------------------------
Sap per Meter Stats
Ethernet Null 0 The SAP is identified by the port.
Ethernet Dot1q 0 — 4094 The SAP is identified by the 802.1Q tag on the port.
Note that a 0 qtag1 value also accepts untagged packets
on the dot1q port.
Ethernet QinQ qtag1: 0 — 4094
qtag2: 0 — 4094
The SAP is identified by two 802.1Q tags on the port.
Note that a 0 qtag1 value also accepts untagged packets
on the dot1q port.