Alcatel-Lucent 7705 - Replacing a CSM

Initializing and Provisioning
7705 SAR-M Chassis Installation Guide 137
Automatic Discovery Protocol
Automatic Discovery Protocol (ADP) is a factory-installed boot option that automates the
initial commissioning of 7705 SAR-M nodes. When the 7705 SAR-M is started for the first
time, an ADP keyword in the BOF causes automatic discovery to run as part of the TiMOS
application image.
In the console session, during the boot-up sequence, you can change the boot options before
the application image is loaded. On systems that support ADP, you will be presented with the
following additional options:
• enable/disable ADP
• specify an optional identifier and optional VLAN
• modify the location where the newly discovered configuration will be stored
For more information about ADP and the BOF file, refer to the 7705 SAR OS Basic System
Configuration Guide, “Automatic Discovery Protocol”.
ADP can be controlled via the CLI while it is running or by the ACO/LT button on the
7705 SAR-M chassis. You can use the ACO/LT button to terminate or retry ADP or to reboot
the chassis. For ADP CLI commands, refer to the 7705 SAR OS OAM and Diagnostics
Guide, “Tools Commands”.
Table 26 lists the ADP commands you can perform with the ACO/LT button.
Table 26: ADP Front Panel Interface Commands
Command Instructions Notes
Enter front panel
interface mode
Hold down the ACO/LT button
for at least 3 s
Once the user interface mode is
activated, you have 5 s to enter the
commands. The user interface
mode is also activated when ADP is
halted, or whenever it enters a new
stage of discovery.
Terminate ADP Enter the front panel interface,
then press the ACO/LT button
quickly two times
Wait 5 s for the command to take
effect
Retry ADP Press the ACO/LT button
quickly once
Wait 5 s for the command to take
effect
Reboot the
chassis
Enter the front panel interface,
then hold down the ACO/LT
button for at least 3 s
Wait 5 s for the command to take
effect