Alcatel-Lucent 7705 - Telnet Connection; Figure 34 Management Port Connection

Establishing Router Management Connections
140 7705 SAR-M Chassis Installation Guide
To establish a console connection:
Step 1. Connect the terminal to the Console port on the front panel (Figure 33) using an
RJ-45 CAT5E cable.
Step 2. Power on the terminal.
Step 3. Establish the connection by pressing the <Enter> key a few times on your terminal
keyboard.
Step 4. At the router prompt, enter the login and password.
The default login is admin.
The default password is admin.
Telnet Connection
Telnet access via a connection to the Management port provides the same options for user and
administrator access as those available through the Console port. You can access the router
with a Telnet connection from a PC or workstation connected to the network once the
following conditions are met:
• the router has successfully initialized
• the Management port (see Figure 34) has been configured using the bof>address
command (see CLI Syntax below)
CLI Syntax: bof
address ip-prefix/ip-prefix-length
where:
ip-prefix is of the form a.b.c.d
ip-prefix-length is 0 to 32
For more information about configuring router parameters, refer to the 7705 SAR OS Router
Configuration Guide. For pinout information, refer to Management Port Pinouts.
Figure 34: Management Port Connection
Crit.
7705 SAR-M
Maj.
Min.
Stat
ACO/
LT
External Alarms
Max, 50 mA
-48/+24 VDC
Mgmt
To D
Lnk Act
Sync In
Sync Out
1
T1/E1 Ports
Stat
3
Stat
5
Stat
7
Stat
9
Stat
11
Stat
13
Stat
15
Stat
2 16
BATT A
BATT B
+Batt A -Batt A +Batt B -Batt B
Console
Link
Act
7
Link
Act
6
Link
Act
5
4321
Link
Act
Link
Act
Link
Act
Link
Act
21114
Management port