Standards and Protocol Support
170 7705 SAR-M Chassis Installation Guide
Telecom Compliance
ACTA TIA-968-B—Telecommunications Telephone Terminal
Equipment Technical Requirements for Connection of
Terminal Equipment to the Telephone Network
ANSI/TIA/EIA-422-B—Electrical Characteristics of Balanced
Digital Interface Circuits, Electronic Industries
Association Engineering Department. Washington D.C.
1994
AS/ACIF S016 (Australia/New Zealand)—Requirements for
Customer Equipment for connection to hierarchical digital
interfaces
IC CS-03 Issue 9—Spectrum Management and
Telecommunications
IEEE 802.1ag—Service Layer OAM
IEEE 802.1p/q—VLAN Tagging
IEEE 802.3—10BaseT
IEEE 802.3ah—Ethernet OAM
IEEE 802.3u—100BaseTX
IEEE 802.3x —Flow Control
IEEE 802.3z—1000BaseSX/LX
IEEE 802.3-2008—Revised base standard
IEEE 802.1AX-2008—Link Aggregation Task Force (transferred
from IEEE 802.3ad)
IEEE C37.94-2002—N Times 64 Kilobit Per Second Optical Fiber
Interfaces Between Teleprotection and Multiplexer
Equipment
ITU-T G.703—Physical/electrical characteristics of hierarchical
digital interfaces
ITU-T G.704—Synchronous frame structures used at 1544, 6312,
2048, 8448 and 44 736 kbit/s hierarchical levels
ITU-T G.707—Network node interface for the Synchronous Digital
Hierarchy (SDH)
ITU-T G.712-2001—Transmission performance characteristics of
pulse code modulation channels
ITU-T G.957—Optical interfaces for equipments and systems
relating to the synchronous digital hierarchy
ITU-T G.984.1—Gigabit-capable passive optical networks
(GPON): general characteristics
ITU-T V.11 (RS-422)—V.11/X.27 Electrical characteristics for
balanced double-current interchange circuits operating at
data signalling rates up to 10 Mbit/s
ITU-T V.24—List of definitions for interchange circuits between
data terminal equipment (DTE) and data circuit-
terminating equipment (DCE)
ITU-T V.28 (V.35)—V.28 Electrical characteristics for unbalanced
double-current interchange circuits
ITU-T V.36—Modems for synchronous data transmission using 60-
108 kHz group band circuits
ITU-T X.21—Interface between Data Terminal Equipment and
Data Circuit- Terminating Equipment for Synchronous
Operation on Public Data Networks
ITU-T Y.1731—OAM functions and mechanisms for Ethernet-
based networks
Protocol Support
ATM
RFC 2514—Definitions of Textual Conventions and
OBJECT_IDENTITIES for ATM Management, February
1999
RFC 2515—Definition of Managed Objects for ATM Management,
February 1999
RFC 2684—Multiprotocol Encapsulation over ATM Adaptation
Layer 5
af-tm-0121.000—Traffic Management Specification Version 4.1,
March 1999
ITU-T Recommendation I.610—B-ISDN Operation and
Maintenance Principles and Functions version 11/95
ITU-T Recommendation I.432.1—B-ISDN user-network interface -
Physical layer specification: General characteristics
GR-1248-CORE—Generic Requirements for Operations of ATM
Network Elements (NEs). Issue 3 June 1996
GR-1113-CORE—Bellcore, Asynchronous Transfer Mode (ATM)
and ATM Adaptation Layer (AAL) Protocols Generic
Requirements, Issue 1, July 1994
AF-PHY-0086.001—Inverse Multiplexing for ATM (IMA)
BFD
draft-ietf-bfd-mib-00.txt—Bidirectional Forwarding Detection
Management Information Base
draft-ietf-bfd-base-o5.txt—Bidirectional Forwarding Detection
draft-ietf-bfd-v4v6-1hop-06.txt—BFD IPv4 and IPv6 (Single Hop)
draft-ietf-bfd-multihop-06.txt—BFD for Multi-hop Paths
BGP
RFC 1397—BGP Default Route Advertisement
RFC 1997—BGP Communities Attribute
RFC 2385—Protection of BGP Sessions via MDS
RFC 2439—BGP Route Flap Dampening
RFC 2547bis—BGP/MPLS VPNs
RFC 2918—Route Refresh Capability for BGP-4
RFC 3107—Carrying Label Information in BGP-4
RFC 3392—Capabilities Advertisement with BGP-4
To Next Page
Loading...
