Alcatel-Lucent 7705 - Filler Plate; T1;E1 and Ethernet Ports; Figure 11 Module Slot; Figure 12 Filler Plate

7705 SAR-M Components
60 7705 SAR-M Chassis Installation Guide
Figure 11: Module Slot
For additional information on modules, refer to the specific module documentation.
Filler Plate
Filler plates are available for the two chassis variants that have module slots. If the module
slot is empty, a filler plate (blank panel) must be installed to help control airflow, help confine
electromagnetic interference, and for safety reasons. Figure 12 shows the filler plate.
Figure 12: Filler Plate
T1/E1 and Ethernet Ports
Two variants of the 7705 SAR-M chassis are equipped with T1/E1 ports. All variants of the
7705 SAR-M chassis are equipped with Ethernet ports. Figure 13 identifies the T1/E1 and
Ethernet interface ports. These ports provide access for a wide variety of interface speeds and
types, including Ethernet (1000Base-T and optical), T1/E1 with ATM and IMA, and TDM
(channelized and unchannelized).
The chassis variants with 16 T1/E1 ports support those connections via RJ-45 connectors. All
16 ports must be configured as either T1 or E1; a mix of T1 and E1 ports is not supported.
The T1/E1 ports are on-premises, intra-building SELV ports and must only be connected to
other SELV ports. Odd-numbered ports are located on the top row, and even-numbered ports
are located on the bottom row.
21102
T1/E1 Ports
7
Stat
1
Stat
2
3
Stat
5
Stat
9
Stat
Link
Act
7
Link
Act
6
Link
Act
5
4321
Link
Act
Link
Act
Link
Act
Link
Act
Module slot
21283