Initializing and Provisioning
7705 SAR-M Chassis Installation Guide 135
Extended checks enabled with overhead of 36B
Switching serial output to sync mode... done
Waiting for USB ...
Looking for cf3:/bof.cfg ... OK, reading
Contents of Boot Options File on cf3:
primary-image ftp://*:*@138.120.209.30/./images/CEPE/both.tim
primary-config ftp://*:*@138.120.209.30/./images/CEPE/dut-a.cfg
address 138.120.209.71/24 active
primary-dns 138.120.252.56
dns-domain labs.ca.alcatel-lucent.com
static-route 138.120.0.0/16 next-hop 138.120.209.1
autonegotiate
duplex full
speed 100
wait 3
persist off
console-speed 115200
Hit a key within 3 seconds to change boot parms...
Primary image location: ftp://*:*@138.120.209.30/./images/CEPE/both.tim
Initializing management port tme0 using IP addr 138.120.209.71.
Initial DNS resolving preference is ipv4-only
Loading image ftp://*:*@138.120.209.30/./images/CEPE/both.tim
Version B-0.0.I393, Tue May 25 19:36:08 EDT 2010 by cepbuild in /rel0.0/I393/panos/main
text:(43735079-->104446888) + data:(2072545-->12172224)
Executing TiMOS image at 0x2800000
When the system finds the boot.ldr file, the system processes the initialization parameters
from the BOF. The BOF should be on the same drive as the boot.ldr file. If the BOF
cannot be found or loaded, then the system prompts the user for alternate software and
configuration file locations.
When the software is successfully loaded, control is passed from the boot loader file to the
software. The runtime software attempts to locate the configuration file as configured in the
BOF. The file includes configurations for the chassis, control and switching functions, and
ports, as well as system, routing, and service configurations.
Figure 32 displays the compact flash directory structure and file names.
Figure 32: Files on the Compact Flash
TiMOS-m.n.Yz
both.tim
config.cfgboot.ldrbof.cfg
Root
19644
To Next Page
Loading...
