DC Power Connections
7705 SAR-M Chassis Installation Guide 95
Note:
• The 7705 SAR-M requires a minimum of one DC power source to operate, but using
two DC power sources is recommended for redundancy.
• The 7705 SAR-M is suitable for both DC-I and DC-C power configurations.
• All bare conductors must be coated with an appropriate antioxidant compound before
crimp connections are made. All unplated connectors, braided straps, and bus bars
must be brought to a bright finish and then coated with an antioxidant before connecting
them.
To Next Page
Loading...
