Alcatel-Lucent 7705 - Table 23: Adapter Card Installation Features; Figure 27: Installing an Adapter Card

Installing the Components
Page 102 7705 SAR-8 Installation Guide
To maintain EMC compliance, cables that are shielded and grounded at both ends must be
used with the adapter card interfaces. Use CAT5 shielded cables with Fast Ethernet
interfaces and CAT5E shielded cables with Gigabit Ethernet interfaces (electrical).
Refer to Replacing Adapter Cards on page 140 for general information on replacing an
adapter card. For information on replacing a specific adapter card, as well as information on
its connectors and LEDs, refer to the appropriate adapter card installation guide.
Tools required:
• torque driver for Phillips screws
Figure 27: Installing an Adapter Card
Table 23: Adapter Card Installation Features
Key Description
1 Slot guide
2 Threaded receptacle
3 Captive screw
4 Ejector lever
A16-CND31
Stat
Pwr
Act
Ports 1-16
Port
Minor
Major
Critical
Batt B
Batt A
Fan
Alarm
External
Alarms
FAN
7705 SAR-8
CSM A
SLOT ID
MDA 1
MDA 3
MDA 5
CSM B
MDA 2
MDA 4
MDA 6
4
3
3
2
1
4
19643
Batt. A
-
+
-
+
Batt. B