Alcatel-Lucent 7705 - RJ-45 Distribution Panel

7705 SAR-8 Overview
Page 54 7705 SAR-8 Installation Guide
RJ-45 Distribution Panel
Figure 12 shows the RJ-45 Distribution panel. Table 3 lists the panel features.
The RJ-45 panel provides 100-ohm T1 or 120-ohm E1 access to 32 ports. On the customer
side, each port has an RJ-45 connector (see RJ-45 Distribution Panel on page 156 for pinout
information). On the equipment side, the panel has two sets of 68-pin AMP connectors for
connection to two 16-port T1/E1 ASAP cards via 68-pin AMP to 68-pin AMP T1/E1 cables
(see T1/E1 Cables on page 57). One set of AMP connectors on the panel is for network ports
1 to 16, and the other set is for network ports 17 to 32.
Figure 11: Mini-Coaxial Distribution Panel
17 18 19 20 21 22 23 24
25 26 27 28 29 30 31 32
TX 17 - 24
RX 17 - 24
TX 25 - 32
RX 25 - 32
87654321
161514131211109
TX 1 - 8
TX
SPARE EXT/
RX/1732-M4
TX
MAIN
RX/1732-M2
M3
SPARE EXT/
TX/ RX-1/-M6
M1 TX/ RX-1/-M6
MAIN
RX 1 - 8
TX 9 - 16
RX 9 - 16
Front
Back
1 12
19946
Note: A set of connectors consists of one MAIN connector and one SPARE connector. When
connecting to 16-port T1/E1 ASAP Adapter cards, always use the (bottom) connectors
labeled MAIN.
Figure 12: RJ-45 Distribution Panel
TX
SPARE EXT/
RX/1732-M4
TX
MAIN
RX/1732-M2
M3
SPARE EXT/
TX/ RX 1/- 16
M1 TX/ RX 1/- 16
MAIN
Front
Back
1 12
12
I/O
I/O
34
9101112
56
I/O
I/O
78
13 14 15 16
17 18
I/O
I/O
19 20
25 26 27 28
21 22
I/O
I/O
23 24
29 30 31 32
19604