Alcatel-Lucent 7705 - Management Port Pinouts; Console Port

Appendix C: Pinout Assignments
7705 SAR-8 Installation Guide Page 151
Management Port Pinouts
Table 32 displays the Management port pin assignments.
Console Port
The Console port is a Universal Asynchronous Receiver/Transmitter (UART) port used to
configure router and system parameters. It can also be used for monitoring purposes. The
Console port is enabled by default and is configured as DTE. The default baud rate is
115 200. This port has a DB9 male connector. Connect the Console port to a terminal using
an EIA/TIA-232 serial cable.
Figure 46 shows the Console port pin numbers.
Table 32: Ethernet Management Port Pinouts—RJ-45 Female
Pin Signal Direction Description
1 TX+ Output Differential transmit data – positive
2 TX- Output Differential transmit data – negative
3 RX+ Input Differential receive data – positive
4 NC — Not connected
5 NC — Not connected
6 RX- Input Differential receive data – negative
7 NC — Not connected
8 NC — Not connected
Figure 46: Console Port Pin Numbers
6
9
5
1
19862