Initializing and Provisioning
7705 SAR-8 Installation Guide Page 119
Step 3. Verify the operational status of the router components by checking all the LEDs on
the following components:
→ Fan module (refer to Fan Module Connectors and LEDs)
→ CSM (refer to CSM Connectors and LEDs)
→ Adapter cards (refer to the appropriate adapter card installation guide)
Step 4. After verifying the LEDs, establish communication with the router via the Console
port. Refer to Console Connection.
Step 5. (Optional at this time) Assign an IP address to the CSM. Refer to Telnet Connection
for quick reference information and to the 7705 SAR OS Basic System Configuration
Guide for detailed information.
Step 6. (Optional at this time) Configure or modify the primary, secondary, or tertiary BOF
file locations. Refer to Telnet Connection for reference information and to the 7705
SAR OS Basic System Configuration Guide for detailed information.
Troubleshooting Initial Startup
If the system cannot load or cannot find the boot.ldr file on the compact flash memory
device (cf3), the system will continuously reboot in an attempt to successfully find and load
the boot.ldr file. If this happens, the CSM should be replaced and the faulty CSM
returned to Alcatel-Lucent. The example below displays the output when the boot.ldr
file cannot be found.
Example: Rebooting display
Rebooting...
Alcatel 7705 Boot ROM. Copyright 2007 Alcatel-Lucent.
All rights reserved. All use is subject to applicable license agreements.
Build: X-0.0.I166 on Wed Aug 8 23:22:35 EDT 2007 by csabuild
Version: 0x1C
Processor core is xxxxXX
COLD boot on processor #1
?Preparing for jump to RAM...
Starting bootrom RAM code...
Boot rom version is v28
>>>Octeon BIST check passed.
>>>Testing SDRAM from 0x02200000 to 0x40000000
>>>Testing Compact Flash ... Slot Empty
Board Serial Number is 'NS073640003'
Platforms in BP EEProm is 0x8
Chassis type 9 (csa8) found in BP EEProm
Chassis Serial Number is 'A60511000005'
Searching for boot.ldr on local drives:
No disk in cf3
No disk in cf3
No disk in cf3
Error - file boot.ldr not found on any drive
Please insert CF containing boot.ldr. Rebooting in 5 seconds.
To Next Page
Loading...
