7705 SAR-8 Installation Guide Page 23
Preface
About This Guide
This guide provides site preparation recommendations, step-by-step procedures to install the
Alcatel-Lucent 7705 Service Aggregation Router (SAR) in a standard 19-inch utility rack,
and instructions to install, provision, and remove the Control and Switching Module (CSM),
adapter cards, and Fan module.
After the hardware installation process is completed, refer to the 7705 SAR OS
documentation set for details on the boot process, software configuration, and Command
Line Interface (CLI) information to configure system and network parameters.
List of Technical Publications
The 7705 SAR-series OS documentation set is composed of the following guides:
• 7705 SAR OS Basic System Configuration Guide
This guide describes basic system configurations and operations.
• 7705 SAR OS System Management Guide
This guide describes system security and access configurations as well as event
logging and accounting logs.
• 7705 SAR OS Interface Configuration Guide
This guide describes card and port provisioning.
• 7705 SAR OS Router Configuration Guide
This guide describes logical IP routing interfaces, IP-based filtering, and routing
policies.
• 7705 SAR OS MPLS Guide
This guide describes how to configure Multiprotocol Label Switching (MPLS),
Resource Reservation Protocol for Traffic Engineering (RSVP-TE), and Label
Distribution Protocol (LDP).
To Next Page
Loading...
