Initializing and Provisioning
Page 122 7705 SAR-8 Installation Guide
To establish a console connection:
Step 1. Connect the terminal to the Console port on the front panel (Figure 35) using the
serial cable.
Step 2. Power on the terminal.
Step 3. Establish the connection by pressing the <Enter> key a few times on your terminal
keyboard.
Step 4. At the router prompt, enter the login and password.
The default login is admin.
The default password is admin.
Telnet Connection
Telnet access provides the same options for user and administrator access as those available
through the console port. You can access the router with a Telnet connection from a PC or
workstation connected to the network once the following conditions are met:
• the router has successfully initialized
• the Management port (Figure 36) has been configured using the bof>address
command (see CLI Syntax)
CLI Syntax: bof
address ip-prefix/ip-prefix-length [primary |
secondary]
where:
ip-prefix is in the a.b.c.d format
ip-prefix-length is a value in the range [0..32]
For more information about configuring router parameters, refer to the 7705 SAR OS Router
Configuration Guide. For pinout information, refer to Management Port Pinouts on page
151.
Figure 36: Management Port Connection
Stat
Mgmt Port
In Out
Sync
CSM
Pwr
Act
Management port
19646
Console
To Next Page
Loading...
