Alcatel-Lucent 7705 - Changing the Adapter Card Configuration

Appendix B: Field-Replaceable Units
7705 SAR-8 Installation Guide Page 141
Changing the Adapter Card Configuration
If you replace an adapter card with a different type, you must change the configuration to
reflect the new adapter card type prior to removing the installed card. Each active port must
be shut down before you shut down and remove an adapter card configuration. If you replace
an adapter card with the same type, no configuration change is necessary. Refer to the
7705 SAR OS Interface Configuration Guide for details on configuring cards and ports.
Issue the following commands in the config context to shut down ports, remove the
adapter card from the configuration, and change to an 8-port Ethernet Adapter card:
Command Example
Step 1.port port-id* port 1/1/5
Step 2.shutdown shutdown
*Note: The port>shutdown command must be repeated for all enabled ports on
the adapter card.
Step 3.exit exit
Step 4.card slot-number card 1
Step 5.mda mda-slot mda 1
Step 6.shutdown shutdown
Step 7.exit exit
Step 8.no mda mda-slot no mda 1
Step 9.mda mda-slot mda 1
Step 10.mda-type mda-type mda a8-eth
Step 11.no shutdown no shutdown
Step 12.exit exit