Initializing and Provisioning
7705 SAR-8 Installation Guide Page 121
Establishing Router Management Connections
There are two ways to access management of the 7705 SAR-8:
• Console connection
• Telnet connection
Console Connection
The console port on the CSM is a male DB9 connector. To establish a console connection,
you need the following:
• an ASCII terminal or a PC running terminal emulation software set to the
parameters shown in Table 28
• a standard serial cable with a female DB9 connector
For pinout information, refer to Console Port Pinouts on page 152.
Table 28: Console Port Default Settings
Parameter Value
Gender DTE
Baud Rate 115 200
Data Bits 8
Parity None
Stop Bits 1
Flow Control None
Figure 35: Console Port Connection
Stat
Mgmt Port
In Out
Sync
CSM
Pwr
Act
Console port
19645
Console
To Next Page
Loading...
