Installing the Components
Page 108 7705 SAR-8 Installation Guide
To disconnect a connector from the 1.0/2.3 mini-coaxial panel using the disconnection tool:
Step 1. Hook the tool over the end of the mini-coaxial connector, as shown in Figure 31.
Take care to avoid scratching or damaging nearby cable.
Step 2. Keep the tool hooked over the connector and firmly pull the tool straight out (towards
you) in order to release the clamping mechanism in the connector and disconnect the
cable. Avoid pulling the tool up and out because the hook may slip off the connector.
Warning: Do not pull on the coaxial cable to help disconnect the cable. This may
damage the cable.
To Next Page
Loading...
