Appendix B: Field-Replaceable Units
7705 SAR-8 Installation Guide Page 143
To remove an adapter card:
Step 1. If you are replacing an adapter card with a different type, change the configuration to
reflect the new adapter card type. See Changing the Adapter Card Configuration on
page 141.
Step 2. Disconnect all cables from the adapter card ports.
Step 3. Use a Phillips screwdriver to loosen the adapter card captive screws.
Step 4. Simultaneously rotate the ejector levers outward to release the adapter card
connectors from the backplane receptacles.
Step 5. Grip the adapter card by the ejector levers and slide the card out of the slot. Place the
adapter card on an anti-static surface.
Step 6. If you are not replacing the adapter card immediately, cover the adapter card slot with
a filler plate. See Installing a Filler Plate on page 148 for instructions on installing a
filler plate.
Note: The adapter card cannot be removed if the captive screws are tightened.
To Next Page
Loading...
