Monitor CLI Commands
Page 126 7750 SR OS Basic System Configuration Guide
subscriber
Syntax subscriber sub-ident-string sap sap-id sla-profile sla-profile-name [base | ingress-queue-
id ingress-queue-id | egress-queue-id egress-queue-id] [interval seconds] [repeat repeat]
[absolute | rate]
Context monitor>service
Description This command monitors statistics for a subscriber.
Parameters sub-ident-string — Specifies an existing subscriber identification profile to monitor.
sap sap-id — Specifies the physical port identifier portion of the SAP definition.
Values dlci 16 — 1022
sla-profile sla-profile-name — Specifies an existing SLA profile.
interval seconds — Configures the interval for each display in seconds
Default 11
Values 11 — 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 — 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
Default mode delta
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed instead
of the delta.
base — Monitor base statistics.
ingress-queue-id ingress-queue-id — Monitors statistics for this queue.
Values 1 — 32
egress-queue-id egress-queue-id — Monitors statistics for this queue.
Values 1 — 8
Sample Output
A:Dut-A# monitor service subscriber alcatel_100 sap 1/2/1:101 sla-profile sla_default
===============================================================================
Monitor statistics for Subscriber alcatel_100
===============================================================================
At time t = 0 sec (Base Statistics)
-------------------------------------------------------------------------------
SLA Profile Instance statistics
-------------------------------------------------------------------------------
Packets Octets
Off. HiPrio : 0 0
Off. LowPrio : 94531 30704535
To Next Page
Loading...
