Starting the OmniAccess 780
Left running head:
Chapter name (automatic)
58
Beta Beta
OmniAccess 780 Hardware Users Guide
Alcatel-Lucent
Step 3: Configure the system.
Once the system bootup is complete, the system enters the “initial configuration
setup” mode, which is an interactive mode for configuring the system. Follow the
prompts on the screen to input the required information.
For further customizing and changing the configuration, it would be necessary to
use the full-fledged CLI access to the system. To use the CLI and to know more
about its usage, refer to the “OmniAccess 700 CLI Configuration Guide”.
Step 4: If all the activities have proceeded normally and if the initial configuration
is complete, the OA-780 is installed, and is now ready for deployment in your
network.
To Next Page
Loading...
Need help?
General
