Starting the OmniAccess 780
Left running head:
Chapter name (automatic)
56
Beta Beta
OmniAccess 780 Hardware Users Guide
Alcatel-Lucent
CHECKING CONDITIONS PRIOR TO SYSTEM STARTUP
Before you power ON the OA-780, check the following:
1. Ensure that the power supply tray is securely inserted into the chassis.
2. Ensure that the utility power cable is connected to a valid power source and power
is available from this source.
3. Ensure that the Switch Fabric and the SE modules are correctly and securely
installed.
4. Ensure that a PC or VT100 terminal is connected to the console port, using the
appropriate console cable. (If the system is not connected to a console, see
“Connecting to the System Console Port” chapter of this guide to connect the
system to a console.)
STARTING THE OA-780
After installing your OA-780 and connecting cables, follow the procedure given
below to start the system:
Step 1: Power ON the OA-780.
Power on the OA-780 by turning on the external power switch located near the
power cable on the power supply tray. If power supply is available, you can hear
the rotation of system fans, and the system begins the bootup sequence.
Step 2: Monitor the system for various bootup messages.
Once the system begins to startup, monitor the front panel LEDs for various
stages of booting process.
In addition to the LEDs, monitor the system console for various bootup text
messages. While a console access is not always required for system startup, it is
a good idea to monitor the console at least the first time the system is booted and
initial configurations completed.
To Next Page
Loading...
Need help?
General
