Installing the OmniAccess 780
Left running head:
Chapter name (automatic)
34
Beta Beta
OmniAccess 780 Hardware Users Guide
Alcatel-Lucent
PREPARING FOR INSTALLATION
The OA-780 is shipped with all the user modules installed in the chassis.
However, optional modules may be shipped in a separate package from the main
system.
If you wish to install the components on your own, you need to understand the
proper installation procedure and the safety guidelines involved in performing the
same.
If you notice any deviations in the contents received as against the order, contact
Alcatel-Lucent Technical Support immediately.
REQUIRED TOOLS AND EQUIPMENT
You need the following items to install the OA-780:
• ESD-preventive wrist strap
• Antistatic mat
• No. 2 Phillips screwdriver
• 1/4-in. flat-blade screwdriver
• Tape measure (optional)
• Level (optional)
• A total of 12 M5 x 10-mm Phillips flathead screws to secure the brackets to the
chassis
• A total of 16 slotted 10-32 x 3/8 screws for rack installation
To Next Page
Loading...
Need help?
General
