Starting the OmniAccess 780
Left running head:
Chapter name (automatic)
60
Beta Beta
OmniAccess 780 Hardware Users Guide
Alcatel-Lucent
Step 1: Connect the RJ-45 end of the console cable to the front-panel console
port on the OA-780 and the DB-9 end to the serial-port (COM) on your computer/
terminal.
Step 2: Start your terminal emulation software.
Example: kermit or hyperterm terminal (if you are using Microsoft Windows
operating system) or minicom terminal (if you are using Unix/Linux operating
system).
Step 3: Set the console session as follows:
Table 23: Console Properties
Step 4: Watch for console message output or press the Enter key to get the
device prompt.
Parameter Value
Baud rate 9600
Parity None
Data Bits 8
Stop Bit 1
Flow control None
To Next Page
Loading...